KIT-Will of the Force Acrylic Lightsaber Blade

*Blade only, does not come with a hilt*

The Will of the Force acrylic blade is ~90cm.

Each lightsaber blade is made of 10mm thick acrylic sheet and the inscriptions are made with machine engraving.

All lightsabers have a 1inch connector so will fit any standard 1″ lightsaber.

These are not fit for dueling, any dueling may damage the blades.

The engraving in Aurebesh says “By the Will of the Force”

This is a kit version of the acrylic blade, it requires the following steps:
– Sand down the bevel on the edge/s of the blade (belt sander works the best)
– Sand off the support on the 3D printed coupler (black bit)
– Glue 3D printed coupler into the section of lightsaber blade (white bit), epoxy resin or super glue works
– Glue the sanded blade into the 3D printed coupler/lightsaber blade section. Do not use super glue, it will fog the acrylic. Use 2 part epoxy glue or another glue that does not fog acrylic.