KIT-Arwen Acrylic Lightsaber Blade

*Blade only, does not come with a hilt*

Arwen’s acrylic blade is ~80cm.

Each lightsaber blade is made of 10mm thick acrylic sheet and the inscriptions are made with machine engraving.

All lightsabers have a 1inch connector so will fit any standard 1″ lightsaber.

These are not fit for dueling, any dueling may damage the blades.

This is a kit version of the acrylic blade, it requires the following steps:
– Sand down the bevel on the edge/s of the blade (belt sander works the best)
– Sand off the support on the 3D printed coupler (black bit)
– Glue 3D printed coupler into the section of lightsaber blade (white bit), epoxy resin or super glue works
– Glue the sanded blade into the 3D printed coupler/lightsaber blade section. Do not use super glue, it will fog the acrylic. Use 2 part epoxy glue or another glue that does not fog acrylic.